10In order to perform each of the following six functions, the lock must rst be placed in Programming Mode:*If no input within 10 seconds, Yellow LED
11IN8-MODKEYPADLL 09/17/2010Restoring the Lock to Factory Default Setting• Remove power (disconnect 9V battery) from Lock • Press and Hold EMTEK but
ASSA ABLOY is the global leader in door opening solutions, dedicated to satisfying end-user needs for security, safety and convenience.Copyright © 201
234b24a4d4ITEM NO. DESCRIPTION QTY.1 Key 22 Outside Trim Plate Assembly 13 Latch Assembly 2 ⁄” or 2 ¾” Backset14 Inside Trim Plate Assembly 1
31-1/8"2-3/4"
4UnlockedLocked
64. Install Inside ChassisCAM LINK MUST REMAIN IN THE CORRECT POSITION DURING INSTALLATION.!Step 1: Conrm the position of Cam Link.For Left Hand Loc
7CHECK ALIGNMENT BEFORE FULLY TIGHTENING SCREWS.!Step 4: Connect Wire Harness (A) and tuck Connectors as shown (B).ABStep 5: Install Battery.For op
8*Locked position is required for installation and removal of the Inside Trim Plate Assembly. (Does not apply to Keypad Storeroom/Gate product) *Lock
9112EMTE KYour Emtek lock is shipped with two 4-digit user codes and a 6-digit programming code. These codes are randomly generated at the factory. (T
Comments to this Manuals